ADTRAN Total Access 850 System Manual page 186

Section 4 User Interface Guide
Router Options – T1 Interface (L2 Protocol = FRE or PPP)
Step
1 From the main menu, select R
2 Use the right arrow key to highlight C
Select I
S
ETUP
3
on the T1 interface defined in the DLCI M
R
OUTER
4 Set A
Select the desired A
5
more details.
Enter the Total Access 850 L
6
for the selected virtual circuit.
7 Enter the IP address for the next hop router in the F
For NAT configuration, refer to Appendix C. RFC1483 Quick Start (IP Routing
8
with NAT) on page 209.
9 Left arrow back to the main menu to save the changes.
Step
1 From the main menu, select R
2 Use the right arrow key to highlight C
Select R
3
appropriate IP address.
4 Left arrow back to the main menu to save the changes.
4. Mapping the DS0s
For more details on the configuration parameters discussed in this section, refer to the following pages:
DS0 Map menus beginning on
186
and press <E
NTERFACES
field for the T1 interface and press <E
I table.
NTERFACES
to Y to activate the virtual circuit.
CTIVE ES
M
DDRESS
OCAL
Router Options – Setting the Default Gateway
and press <E
OUTES
page 180
© 2004 ADTRAN, Inc.
Action
and press <E
OUTER NTER
and press <E
ONFIG
>. Use the right arrow key to highlight the
NTER
>. Each PVC (frame relay)
NTER
has a separate listing in the
AP
. Refer to Address Mode on page 151 for
ODE
IP A and corresponding IP N
DDRESS
AR
Action
and press <E
OUTER NTER
and press <E
ONFIG
>. Set the D
NTER EFAULT
Total Access 850 System Manual
>.
>.
NTER
ETMASK
-E IP A field.
ND DDRESS
>.
>.
NTER
G field to the
ATEWAY
64203376L1-1B