ADTRAN Total Access 850 System Manual page 149

Total Access 850 System Manual
R > C > I
OUTER ONFIG
Configure the Ethernet addressing, RIP, and Proxy ARP from this menu.
P IP
RIMARY
This is used to setup the IP addresses for the LAN on the unit.
IP A
DDRESS
The IP address assigned to the unit's Ethernet port is set here. This address must be unique within
the network. Default is
S M
UBNET ASK
This is the IP network mask that is to be applied to the unit's Ethernet port. Default is
255.255.255.0.
RIP
Use this menu to enable RIP on the LAN interface.
V
ERSION
Enables or disables RIP and specifies the RIP protocol. Choices are;
RIP), V1 (RIP Version 1) or
M
ETHOD
Specifies the way the RIP protocol sends out its advertisements. The following options are
available:
S
PLIT
P
OISON
D
IRECTION
Allows the direction at which RIP advertisements are sent and received to be specified.
TX
AND
TX O
NLY
RX O
NLY
64203376L1-1B
(ETH)> S
NTERFACES
10.0.0.1 .
V2 (RIP Version 2). The default is
H (DEF) Only routes not learned from this circuit are advertised.
ORIZON
R All routes are advertised, but the routes learned from this port
EVERSE
are "poisoned" with an infinite metric. The default is Split
Horizon.
RX ( )
RIP advertisements are periodically transmitted and are listened
DEF
to on this port.
RIP advertisements are periodically transmitted but are not
listened to on this port.
RIP advertisements are listened to on this port, but are not
transmitted on this port.
© 2004 ADTRAN, Inc.
ETUP
Section 4 User Interface Guide
O (which disables
FF
O .
FF
149