Interfaces (V35) - ADTRAN Total Access 850 System Manual

Section 4 User Interface Guide
I (V35)
NTERFACES
View the V.35 interface status and configure the V.35 parameters from this menu.
I (V35) > C
NTERFACES
Configure the DTE leads from this menu.
I (V35) > C
NTERFACES
Sets the control characteristic of the clear-to-send lead. Choices are
Default is N .
ORMAL
I (V35) > C
NTERFACES
Sets the control characteristic of the carrier detect lead. Choices are
network interface) or
F
ORCE ON
I (V35) > C
NTERFACES
Sets the control characteristic of the data set ready lead. Choices are
Default is N .
ORMAL
I (V35) > S
NTERFACES
View the status of the DTE leads from this menu.
I (V35) > S
NTERFACES
View the status of Request to Send (RTS) lead. Possibilities are
I (V35) > S
NTERFACES
View the status of the Data Terminal Read (DTR) lead. Possibilities are
I (V35) > T
NTERFACES
These options are used to loopback tests.
I (V35) > T
NTERFACES
Enables a local loopback of the V.35 interface. All data received on the V.35 interface is transmitted back
out the interface.
102
ONFIG
> CTS
ONFIG
> DCD
ONFIG
Default is
. N
ORMAL
> DSR
ONFIG
TATUS
> RTS
TATUS
> DTR
TATUS
EST
> L
EST OOPBACK
© 2004 ADTRAN, Inc.
Total Access 850 System Manual
N
ORMAL
N
ORMAL
.
N
ORMAL
or .
O O
FF N
O
FF
(follows RTS) or F
ORCE ON
(follows valid signal on the
(follows DTR) or
F
ORCE ON
and O .
N
64203376L1-1B
.
.