Ubr1Te Access Module (P/N 1180020L1); Table 25. Quad Fxo Module Compliance Codes; Table 26. Ubr1Te Module Faceplate Leds - ADTRAN Total Access 850 System Manual

Total Access 850 System Manual
Compliance Codes
Table 25 provides the compliance codes for the Total Access 850 Quad FXO Module.
CODE
Power Code (PC)
Telecommunication Code (TC)
Installation Code

UBR1TE Access Module (P/N 1180020L1)

Each port of the UBR1TE Access Module provides an ISDN U-interface and allows the transport of Basic
Rate 2B+D information over the T1 carrier and twisted pair wiring.
Faceplate LEDs
The faceplate LEDs provide status information using a color coded message format. Table 26 gives a
description of all faceplate LEDs for the UBR1TE Module when used with the Total Access 850 system.
For these LEDs...
STATUS
REM (Remote)
64203376L1-1B

Table 25. Quad FXO Module Compliance Codes

Table 26. UBR1TE Module Faceplate LEDs

This color light... Indicates that...
OFF both the loop and the carrier synchronization are
established.
Solid RED neither the loop nor the carrier synchronization is
established.
Blinking RED (every loop synchronization is established, but carrier
two seconds) synchronization is not.
Blinking RED (twice carrier synchronization is established, but loop
every second) synchronization is not.
GREEN Layer 1 is established from the ISDN switch to the
customer ISDN terminal equipment.
Solid AMBER front panel test in progress or the unit is responding to a
2B + D loopback request.
Blinking AMBER the unit is responding to a B1 loopback request or has
(every two seconds) been forced into a B1 loopback from the terminal menus.
Blinking AMBER the unit is responding to a B2 loopback request or has
(twice every second) been forced into a B2 loopback from the terminal menus.
GREEN the unit has been provisioned by the BCU/RCU.
OFF the unit is provisioned by DIP-switches.
© 2004 ADTRAN, Inc.
Section 2 Engineering Guidelines
IN OUT
C C
– X
A –
45