ADTRAN Total Access 850 System Manual page 251

Total Access 850 System Manual
5. Enable "capture" or "logging" in the terminal software, saving it to a file on your computer.
6. Press the SPACE BAR to continue. The router will then print its configuration to the terminal screen.
(With capture enabled, the terminal software will capture the configuration and write it to the
designated file.)
7. When the configuration stops printing, end the capture. The router's configuration is now saved to the
designated file.
8. At the terminal prompt, type EXIT to enter the configuration menu of the router.
Always use <
terminal software.
Loading a configuration into the router
The following steps explains the process for uploading the text file back into the Total Access 850 RCU.
These text files can be the entire configuration, or just partial commands that affect specific configuration
changes. The uploading steps are the same, regardless of the size of the file.
1. Establish a connection to the router with the VT100 terminal software either through the rear CRAFT
or RCU faceplate CRAFT port.
2. From the main menu, select S
3. In the terminal software, initiate a SEND TEXT FILE or SEND CFG FILE using the saved configuration
file.
4. Once the file transfer is complete, type SAVE to save the configuration in the unit. Type EXIT to enter
the configuration menu of the router.
Always use <
terminal software.
Entering commands at the command prompt
Precede each instruction with a ">" when manually entering commands at the command prompt. After
entering commands, type
operation and saves all changes.) To save the changes to flash only (without affecting current operation),
return to the menu system and press <
The commands are based on string comparisons with the menu system (with spaces replaced with
underscores). For example, the config command appears at the command prompt exactly as it appears in
the RCU terminal menus. To change a configuration, type in the desired option exactly as it appears on the
menu. For example, to change the T1 timing mode, the command line should read
>sysconfig t1_timing_mode network (sets timing to recover from the network) or
>sysconfig t1_timing_mode internal (sets timing to internal Total Access 850 oscillator) or
>sysconfig t1_timing_mode dsx-1 (sets timing to recover from the DSX-1 interface).
64203376L1-1B
+ > to exit the configuration menu before closing the Telnet or
CTRL L
U , then T
YSTEM TILITY
+ > to exit the configuration menu before closing the Telnet or
CTRL L
at the command prompt. (This applies ALL commands to current
SAVE
>.
CTRL+W
© 2004 ADTRAN, Inc.
M ; press <Enter>.
ERMINAL ODE
Section 5 DLP-13
251