Dlp-5 Connecting To The Total Access 850 Using Telnet - ADTRAN Total Access 850 System Manual

DLP-5 Connecting to the Total Access 850 Using Telnet

Introduction
The Total Access 850 comes pre-programmed for default Telnet access. The following IP
parameters apply:
•
•
•
•
For security purposes, change the default Telnet password during the initial unit
configuration. (Refer to System Config > Management > Telnet Access > User List on
page 77 for more details.)
If the Total Access 850 is part of a management cluster connected to the local network, you may use a PC
connected to the network to Telnet into the unit. This procedure details the steps which must be performed
to Telnet into the unit.
Prerequisite Procedures
Complete DLP-3, Setting IP Parameters for the Total Access 850 and DLP-4, Verifying Communications
Over an IP LAN.
Tools and Materials Required
• Access to a PC or other computer connected to the LAN.
To prevent electrical shock, do not install equipment in a wet location or during a
lightning storm.
Electronic modules can be damaged by static electrical discharge. Before handling
modules, put on an antistatic discharge wrist strap to prevent damage to electronic
components. Place modules in antistatic packing material when transporting or storing.
When working on modules, always place them on an approved antistatic mat that is
electrically grounded.
64203376L1-1B
IP Address: 10.0.0.1
Subnet Mask: 255.255.255.0
User: guest
Password: password
© 2004 ADTRAN, Inc. 225