ADTRAN Total Access 850 System Manual page 193

Total Access 850 System Manual
Appendix C. Configuring the Unit for Voice Applications
Initial Setup
It is best to configure Total Access 850 TDM applications by following the order of the top-level menus.
For example, first configure the system parameters using the
Next, configure the Layer 1 parameters using the
configured, proceed to the Layer 2 setup using the
data "routing" menus (either
S menus. Lastly, configure the physical mappings using the
ECURITY
The following example provides step by step instructions for configuring the Total Access 850 T1 TDM
system ( through
I
NTERFACES
parameters should be set according to your system need. Refer to System Info on page 73 and System
Config on page 75 for more details.
1. Setting up the Interfaces
For more details on the configuration parameters discussed in this section, refer to the following pages:
Network T1 menus beginning on
FXS menus beginning on
Step
1 From the main menu, select I
Highlight the C
2
Right arrow to select F
3
This format must match the format used by the other units in the network.
4 Set the L
This line code must match the line code used by the other units in the network.
Set the E
5
sufficient.
Set the CSU L
6
whether looping to this unit from another unit will be allowed.
64203376L1-1B
I
NTERFACES
L2 P
or ). Establish packet forwarding and blocking using the
B R
RIDGE OUTER
) for a standard voice application. System Info and System Config
DS0 M
APS
page 94
page 103
T1 Interface Setup Instructions
NTERFACES
menu for the T1 interface and press <E
ONFIG
and choose ESF or SF.
ORMAT
C to B8ZS or AMI.
INE ODE
or line build out. The default setting of 0
QUALIZATION
option to E
PBK NABLE
© 2004 ADTRAN, Inc.
Section 4 User Interface Guide
and
S I
YSTEM NFO
menu. Once the Layer 1 information is
menus. Follow the Layer 2 setup with the
ROTOCOL
DS0 M
APS
Action
.
, D , or D A
ISABLE ISABLE
menus.
S C
YSTEM ONFIG
menus.
>.
NTER
B is usually
D
based on
LL
193