ADTRAN Total Access 850 System Manual page 122

Section 4 User Interface Guide
match occurs. If this default entry is not present, the unit falls back to using IARP to determine the
protocols to use with that particular virtual circuit. If a static maintenance protocol is used, at least one
DLCI mapping must be specified.
To insert a new profile, press the I key when over the Num column. A new inserted profile
will always be set up with the default parameters. To copy parameters from an old profile
to this newly inserted profile, use the copy (C) and paste (P) keys. Entire configuration
trees can be copied with this method.
To delete an unused profile, use the D key when the cursor is over the number in the Num
column. Once deleted, the profile is gone permanently.
L2 P (T1 TDM–T1–FRE) > C
ROTOCOL
Displays the index number in the DLCI mapping table.
L2 P (T1 TDM–T1–FRE) > C
ROTOCOL
When this parameter is set to
the unit will ignore the virtual circuit with this DLCI.
L2 P (T1 TDM–T1–FRE) > C
ROTOCOL
Shows the user the physical and logical port associated with each DLCI. This is a read-only field.
L2 P (T1 TDM–T1–FRE) > C
ROTOCOL
This DLCI (Data Link Connection Identifier) number identifies the virtual circuit being configured.
L2 P (T1 TDM–T1–FRE) > C
ROTOCOL
The mode identifies how the data will be forwarded. The choices are:
R IP (def)
OUTE
B A
RIDGE LL
R UIP/B
OUTE RIDGE OTHER
L2 P (T1 TDM–T1–FRE) > C
ROTOCOL
This value is expressed in milliseconds and represents the amount of time the unit will stop transmitting
over a PVC which received a packet with the BECN bit set. Range is
50 .
MILLLISECONDS
L2 P (T1 TDM–T1–FRE) > S
ROTOCOL
View the L2 protocol status for the T1 interface using the Frame Relay protocol.
122
ONFIG
ONFIG
(def), the mapping is used to determine the protocols used. If set to
Y
ES
ONFIG
ONFIG
ONFIG
All IP data for this DLCI will be routed.
All data for this DLCI will be bridged.
All IP data will be routed. All other data will be bridged.
ONFIG
TATUS
© 2004 ADTRAN, Inc.
Total Access 850 System Manual
> DLCI M > N
APPING
> DLCI M > A
APPING
> DLCI M I
APPING NTERFACE
> DLCI M > DLCI
APPING
> DLCI M > M
APPING
> DLCI M > BECN T
APPING
50-5000
UM
CTIVE
N
ODE
(
IMEOUT MSEC
msec; the default is
64203376L1-1B
,
O
)