Security; Ds0 Maps; Initial Setup - ADTRAN Total Access 850 System Manual

Section 4 User Interface Guide

Initial Setup

It is best to configure Total Access 850 TDM applications by following the order of the top-level menus.
For example, first configure the system parameters using the
Next, configure the Layer 1 parameters using the
configured, proceed to the Layer 2 setup using the
data "routing" menus (either
S menus. Lastly, configure the physical mappings using the
ECURITY
The following example provides step by step instructions for configuring the Total Access 850 T1 TDM
system ( through
I
NTERFACES
Config parameters should be set according to your system need. Refer to System Info on page 73 and
System Config on page 75 for more details.
1. Setting up the Interfaces
For more details on the configuration parameters discussed in this section, refer to the following pages:
Network T1 menus beginning on
Ethernet menus beginning on
Step
1 From the main menu, select I
Highlight the C
2
Right arrow to select F
3
This format must match the format used by the other units in the network.
4 Set the L
This line code must match the line code used by the other units in the network.
Set the E
5
sufficient.
Set the CSU L
6
whether looping to this unit from another unit will be allowed.
188
Appendix B. Configuring the Unit for Bridging
or
B R
RIDGE OUTER
) for a standard bridging application. System Info and System
DS0 M
APS
page 94
page 101
T1 Interface Setup Instructions
menu for the T1 interface and press <E
ONFIG
ORMAT
C to B8ZS or AMI.
INE ODE
or line build out. The default setting of 0
QUALIZATION
option to E
PBK
© 2004 ADTRAN, Inc.
S I
YSTEM NFO
menu. Once the Layer 1 information is
I
NTERFACES
menus. Follow the Layer 2 setup with the
L2 P
ROTOCOL
). Establish packet forwarding and blocking using the
DS0 M
Action
.
NTERFACES
and choose ESF or SF.
, D , or D
NABLE ISABLE ISABLE
Total Access 850 System Manual
and menus.
S C
YSTEM ONFIG
menus.
APS
>.
NTER
B is usually
D
A based on
LL
64203376L1-1B