ADTRAN Total Access 850 System Manual page 80

Section 4 User Interface Guide
P
RIVILEGE
The access for this manager can be assigned three levels. The factory default is
N
ONE
G
ET
G /S
ET ET
M IP
ANAGER
This may be used in conjunction with the Netmask field to define a range of manager IPs. A netmask
of 255.255.255.255 defines a single IP as the manager host IP. The default value is
N
ETMASK
The mask is used to determine which bits of the
care." A "1" bit means that the corresponding address bits in the incoming SNMP packet must match
the address bit in the defined
manager host IP. The default value is
S C > M
YSTEM ONFIG
Sets up the trap manager name and IP from this menu.
#
Displays the index number in the SNMP traps table.
This list allows up to 20 managers to be listed to receive traps.
M N is the text string describing the name of the entry. It is intended for easy reference
ANAGER AME
and has no bearing on the SNMP trap function. You can enter up to 31 characters in this field. The
factory default is no entry in the manager name field.
M IP
ANAGER
This is the IP address of the manager that is to receive the traps. The factory default is
S C > M
YSTEM ONFIG
Enables the FDL management and configures mode and IP addresses from this menu.
S C > M
YSTEM ONFIG
This enables the FDL (only in ESF mode) to be used for management. Learning mode can also be enabled
so the unit can "learn" its IP configuration to be used for its FDL management. Once it learns this
information from, for example a Total Access 4303, the configuration items populate. The factory default
is .
O
N
80
No access is allowed for this community or manager.
Manager can only read items.
Manager can read and set items.
M IP . The netmask of 255.255.255.255 defines a single IP as the
ANAGER
0.0.0.0
> SNMP M
ANAGEMENT
> FDL M
ANAGEMENT
> FDL M
ANAGEMENT
© 2004 ADTRAN, Inc.
Total Access 850 System Manual
M IP are significant. A "0" bit means "don't
ANAGER
.
> T
ANAGEMENT RAPS
ANAGEMENT
> M
ANAGEMENT ODE
.
N
ONE
0.0.0.0 .
.
0.0.0.0
64203376L1-1B