ADTRAN Total Access 850 System Manual page 131

Total Access 850 System Manual
L2 P (T1 ATM–T1–ATM) > C
ROTOCOL
This is the ATM Virtual Channel Identifier that serves as an address for the virtual channel cell
transmissions between two devices. The range is
L2 P (T1 ATM–T1–ATM) > C
ROTOCOL
Select the physical and logical method of data transfer over the virtual path. There are three valid
connection entries: R
OUTER
Access 850 integral IP router. Select
system. Select V to connect traffic from this PVC to a voice connection (on a DSX-1 or FXS
OICE
interface).
L2 P (T1 ATM–T1–ATM) > C
ROTOCOL
Use these menus to configure the router parameters for this logical connection from the router to the T1
interface. These menus are only applicable when the
C (R
ONNECTION
Selects the data-link protocol for the PVC connection between the T1 interface and the router.
The choices are:
C (R
ONNECTION
Identifies how the data will be transferred through the Total Access 850 system. The following
choices are available:
R IP (def) – All IP data for this PVC is routed through the Total Access 850 integral
OUTE
router.
B A
RIDGE LL
R IP/B
OUTE
integral router and all other data is bridged through the system.
C (R
ONNECTION
Provides PPP configuration parameters for the PVC. These menus are only visible when the
is set to
M
ODE
A
UTHENTICATION
Contains the required parameters for PPP peer authentication and for being authenticated
by the PPP peer. Authentication is applied between the unit and the PPP peer as
described in the submenus.
64203376L1-1B
ONFIG
ONFIG
, V35 , and V . Select
OICE
V35 to connect traffic from this PVC to a V.35 interface on the
ONFIG
) > S > P
OUTER ETUP ROTOCOL
(def) and .
IP PPP
) > S > M
OUTER ETUP ODE
– All data for this PVC is bridged through the Total Access 850 system.
O – All IP data for this PVC is routed through the Total Access 850
RIDGE THER
) > S > PPP S
OUTER ETUP
.
PPP
© 2004 ADTRAN, Inc.
> PVC C > VCI
ONFIG
. The default setting is
0-65355
> PVC C > C
ONFIG
R to connect traffic from this PVC to the Total
OUTER
> PVC C > S
ONFIG
parameter is set to
C
ONNECTION
ETUP
Section 4 User Interface Guide
.
38
ONNECTION
(R )
ETUP OUTER
.
R
OUTER
131