ADTRAN Total Access 850 System Manual page 151

Total Access 850 System Manual
R > C > I
OUTER ONFIG
This is a read-only field which displays the physical and logical port of the interface using the following
nomenclature: [A.B], where A represents the physical port (network interface is 0, Ethernet is 1) and B
represents the logical port for the Layer 2 protocol (i.e. PVC for Frame Relay, PPP link, etc.) Each
configured logical port is assigned a number corresponding to the order in which they are listed in the L2
Protocol configuration fields.
R > C > I
OUTER ONFIG
Configure the IP parameters for this interface and sub-interface from this menu.
A
CTIVE
This Selection enables IP on this PVC.
VPI
ATM virtual port identifier assigned to this sub-interface in the
only applicable when L2 protocol for this sub-interface is ATM.
VCI
ATM virtual channel identifier assigned to this sub-interface in the
is only applicable when L2 protocol for this sub-interface is ATM.
DLCI
Data Link Connection Identifier assigned to this PVC in the
applicable when L2 protocol for this sub-interface is
A M
DDRESS ODE
Specifies the method the unit uses to determine the local and far-end IP addresses. The choices are
(default),
U S
SER PECIFIED
Local IP and Far-End IP addresses,
address from a DHCP server. IARP allows the unit to determine the far-end IP address using inverse
ARP.
L IP A
OCAL DDRESS
This is the IP address for this PCV. This field is not visible when
C .
LIENT
IP N
ETMASK
This is the network mask used for this interface. This field is not visible when
to DHCP C .
LIENT
64203376L1-1B
(NET) > S
NTERFACES
(NET)> S
NTERFACES
, or
DHCP C
LIENT
DHCP C
© 2004 ADTRAN, Inc.
-I
UB NTERFACE
ETUP
L2 P
L2 P
L2 P
ROTOCOL
.
FRE
. allows the user configuration for
IARP U S
SER PECIFIED
is used for the Total Access 850 to learn his IP
LIENT
A
DDRESS
Section 4 User Interface Guide
menus. This field is
ROTOCOL
menus. This field
ROTOCOL
menus. This field is only
M is set to DHCP
ODE
A M
DDRESS ODE
is set
151