ADTRAN Total Access 850 System Manual page 246

Section 5 DLP-11
Perform the following steps in the order listed.
1. Connect to the Total Access 850 using the rear CRAFT (RJ-45) port on the back of the Total Access 850
or the RCU faceplate CRAFT (DB-9) interface.
If you are not already connected to the unit's rear
with a VT100 compatible terminal or with a PC running VT100 emulation software, follow the
procedure in DLP-1, Connecting a VT100 Terminal or PC to the CRAFT Port. Connecting to the rear
CRAFT or RCU faceplate
2. Log in to the unit.
3. Go to the S U
YSTEM
4. Set the T M
RANSFER
5. Select S C
AVE ONFIG
Total Access 850 for the transfer download.
The following message is displayed: This will begin sending a copy of the current system
configuration.
6. Configure the VT100 terminal or terminal emulation software to R
7. View the C
URRENT
8. From the terminal emulation software, begin the XMODEM transfer by using the appropriate command
sequence. For Windows HyperTerminal, select T
path) and select XMODEM as the transfer method.
If necessary, refer to the terminal emulation software documentation for help.
When specifying the filename, ensure that the saved file has a .cfg extension;
otherwise, the file may not be available for uploading into other Total Access 850
units.
Because XMODEM data is being transferred inband through the menu interface, the VT100 menus of
the Total Access 850 will be inoperable from the rear
can cancel the update at any time within the terminal emulation software. (Please consult the
documentation provided by the terminal emulation software to determine how to do this.)
9. When the transfer has successfully completed, I
and XMODEM D
OWNLOAD
246
CRAFT interface limits the configuration transfer procedure to
menu and select C
TILITY
menu to X
ETHOD MODEM
R to start the transfers. Enter Y to confirm the transfer and prepare the
EMOTELY
T S to verify the progress of the current transfer.
RANSFER TATUS
C displays in the P
OMPLETE
© 2004 ADTRAN, Inc.
CRAFT or RCU faceplate
T
ONFIGURATION RANSFER
.
ECEIVE
>R F
RANSFER ECEIVE
or RCU faceplate
CRAFT
displays in the C
DLE
T
REVIOUS RANSFER
Total Access 850 System Manual
CRAFT interface, either
X
MODEM
menu; press <Enter>.
(and prompt for a filename).
. Enter the filename (including
ILE
interfaces. You
CRAFT
T S
URRENT RANSFER TATUS
S field.
TATUS
64203376L1-1B
only.
field