Oracle Acme Packet 4600 Hardware Installation And Maintenance Manual page 80

Caution
80
To remove a power supply from the Acme Packet 4600 chassis:
1. Remove the power cables from the power supplies.
Figure 6 - 100. Removing the Power Cords
2. With your thumb, push the grey locking tab to the left to unlock the power
supply from the chassis.
Figure 6 - 101. Releasing the Locking Tab
3. Holding the handle, pull the power supply towards you. This will disengage the
power supply from the midplane and the chassis.
4. Continue pulling the power supply towards you until it is completely out of the
chassis.
5. Move the power supply to an ESD-safe location.
NEVER power up a power supply before it is installed in the
Acme Packet 4600 chassis.
Note: Ground yourself with an ESD wrist strap before installing a
power supply.
To install a power supply in the Acme Packet 4600 chassis:
1. Locate the power supply to be installed.
2. Locate the empty power supply slot in the chassis.
Acme Packet 4600 Hardware Installation and Maintenance Guide
System
Power
On Stby
Stby DIS
Console Alarm