Table of Contents
Advertisement
1GbE Copper Cabling
Procedure
Acme Packet 4600 Hardware Installation and Maintenance Guide
Note: Perform all cabling procedures according to the established
standards for your organization.
Shielded CAT 5e or CAT 6 (or higher) Ethernet cables with RJ45 jacks are used for
connecting the Acme Packet 4600 1GbE copper NIUs to your production network
over the signaling and media network ports.
To connect 1GbE Copper cables to the signaling and media ports:
1.
Locate the Ethernet cables you plan to connect to the Acme Packet 4600.
2.
Insert the RJ45 connector on the end of the Ethernet cable into one of the 1GbE
copper NIU media and signaling ports. The release tab on the RJ45 jack will click
into place when you insert it properly.
61
Advertisement
Table of Contents
Need help?
Do you have a question about the Acme Packet 4600 and is the answer not in the manual?
Questions and answers