Table of Contents
Advertisement
Caution
74
standby Acme Packet 4600 will assume all traffic processing and forwarding as the
active system.
This procedure is only applicable to Acme Packet 4600 in an
HA deployment.
To force a Acme Packet 4600 into the standby HA state:
1.
Confirm that the relevant Acme Packet 4600 systems on active and standby are
synchronized with the show health command. Type show health and press
<Enter> on each system as shown in the following.
Acme Packet 4600 Hardware Installation and Maintenance Guide
Advertisement
Table of Contents
Need help?
Do you have a question about the Acme Packet 4600 and is the answer not in the manual?
Questions and answers