Oracle Acme Packet 4600 Hardware Installation And Maintenance Manual page 102

Installing the Chassis
in the Rack
Validating the SSD
Formatting the SSD
102
Perform the reverse of the operations in the Physical System Removal section of this
document.
Please refer to earlier sections of this document for full rack installation procedures.
Oracle recommends that you validate the Solid State Drive installation by running
Acme Packet Session Director diagnostics. All versions from nnCX_diags110.gz and
later include the appropriate tests for validating the SSD. Please refer to the
diagnostics documentation for more information.
In the following procedure, after booting into diagnostics, this preliminary check
ensures that the system recognizes the Solid State Drive.
Password: ******
-> dc
/boot/ - Volume is OK
243 MB
/code/ - Volume is OK
245 MB
/sata/ - Drive Present
476940 MB
Starting Diagnostic Executive...
Comm Express MCH 945 Present.
AHCI Support is Enabled.
Acme Packet Net-Net 4600
Diagnostic Executive Version 1.10
Creation date: Nov 25 2014 11:08:02
Board Level Diagnostics
Date & Time: TUE NOV 25 14:56:01 2014
[diag_proc] ->
After installing the Solid State Drive, you must format it. Details on file system
designs and the formatting procedure may be found in Chapter 9, File System
Maintenance of the Maintenance and Troubleshooting Guide for your software
release.
Acme Packet 4600 Hardware Installation and Maintenance Guide