ABB Relion 670 Series Applications Manual page 230

Section 15
Logic
15.3 Logic for group alarm ALMCALH
15.3.1 Identification
Function description
Logic for group alarm
15.3.2 Application
Group alarm logic function ALMCALH is used to route alarm signals to different LEDs and/or
output contacts on the IED.
ALMCALH output signal and the physical outputs allows the user to adapt the alarm signal to
physical tripping outputs according to the specific application needs.
15.3.3 Setting guidelines
Operation : Enabled or Disabled
15.4 Logic for group alarm WRNCALH
15.4.1 Identification
Function description
Logic for group warning
15.4.1.1 Application
Group warning logic function WRNCALH is used to route warning signals to LEDs and/or output
contacts on the IED.
WRNCALH output signal WARNING and the physical outputs allows the user to adapt the warning
signal to physical tripping outputs according to the specific application needs.
15.4.1.2 Setting guidelines
Operation Enabled or Disabled
224
IEC 61850
identification
ALMCALH
IEC 61850
identification
WRNCALH
© Copyright 2017 Hitachi Power Grids. All rights reserved
IEC 60617 ANSI/IEEE C37.2
identification device number
- -
IEC 60617 ANSI/IEEE C37.2
identification device number
- -
Phasor measurement unit RES670
1MRK 511 407-UUS Rev. J
GUID-64EA392C-950F-486C-8D96-6E7736B592BF v1
GUID-64EA392C-950F-486C-8D96-6E7736B592BF v1
GUID-70B268A9-B248-422D-9896-89FECFF80B75 v1
GUID-0BDD898A-360B-4443-A5CF-7619C80A17F4 v2
GUID-3EBD3D5B-F506-4557-88D7-DFC0BD21C690 v4
GUID-FC0DBB7B-FF86-44BF-83D6-DDF120A176DE v1
GUID-B08F2636-33DA-4937-92EB-1A8AC0909AB4 v2
Application manual