Emerson Control Techniques Epsilon Eb Series Reference Manual page 98

AC Line Filters
The AC line filters used during Control Techniques' compliance testing are listed below.
These filters are capable of supplying the drive input power to the specified drive under
maximum output power conditions.
Epsilon EN Model
Eb-202, Eb-203
EN-204
Eb-205 EN-208
EN-214
Alternately, Control Techniques has also seen good results with the following line filters:
Epsilon
Eb-205
Eb-202, Eb-203, Eb-205
Eb-202
AC Line Filter Installation Notes
• EMC criteria can be met in installations where multiple drives are supplied through a
single filter, however, it is the installers responsibility to verify EMC compliance.
Questions on this subject should be directed to the filter manufacturer.
• It is critical that you keep the filter inputs routed away from any electrical noise sources
to prevent noise from being induced into them and carried out of the enclosure.
Cable to Enclosure Shielding
Shielded motor, feedback, serial communications and external encoder cables were used for
Control Techniques' compliance testing and are necessary to meet the EMC requirements.
Each cable shield was grounded at the enclosure wall by the type of grommet described earlier
and shown in the figure 51.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Control Techniques
Schaffner Part #
FN2070-10/06
FS5278-16/08
FS5278-16/08
FN-258/16
EN Model Part #
Schaffner FN 2070M-16/8
EN-204
Corcom 20EQ1
Schaffner FN 2070M-16/8
EN-208
Corcom 20EQ1
Corcom 20EQ1
Schaffner FN 2070-6-06
Installation
Rating
Part #
960307-01 10A, 240V, 1 Ø
960305-01
16A, 240V, 1 Ø
960305-01
960304-01 16A, 480V, 3 Ø
Rating
20A, 240V, 1 Ø
6A, 240V, 1 Ø
79