Emerson Control Techniques Epsilon Eb Series Reference Manual page 27

Epsilon Eb and EN Drives Reference Manual
• Pulse frequency > 250 kHz
• Pulse command cable length > 25 feet
• Noisy electrical environments
Differential input circuit specifications:
Input frequency maximum
Input device:
Input impedance
Maximum voltage applied to input pins (A, A/) or (B, B/ )
Single Ended (referenced to 0V drive logic)
Differential (referenced to mating differential input)
Maximum common mode voltage
Minimum differential voltage required
Input voltage hysteresis
ECI-44 Terminal
Sync Enc In "A"
Sync Enc In "A/"
Sync Enc In "B"
Sync Enc In "B/"
Single ended input circuit specifications:
Single ended input specifications:
1 MHz maximum input frequency
Internal 330 ohm pull-up to 5 Volt (non-isolated)
1.5 Volt low level
3.5 Volt high level
Output driver requirements:
15 mA sinking (open collector)
5 Volt capacity
8
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Command Pulse-Direction
Connector Pin # Signal
27 Pulse
41 Pulse/
26 Direction
40 Direction/
2 Mhz
AM26C32
12 Kohms each input
+/-10V
+/-10V
+/-7 V
200 mV
60 mV
Pulse-Pulse Pulse Quadrature
Signal Signal
Pulse + A
Pulse +/ A/
Pulse - B
Pulse -/ B/