Table of Contents
Advertisement
Section 3 - Configuration
Select PPPoE (Point-to-Point Protocol over Ethernet) if your ISP uses a PPPoE connection. Your ISP will provide you with a
username and password. This option is typically used for DSL services. Make sure to remove your PPPoE software from your
computer. The software is no longer needed and will not work through the DAP-1260L.
Username:
Enter your PPPoE user name.
Password:
Enter your PPPoE password and then retype
the password in the next box.
Service Name:
Enter the ISP Service Name (optional).
Reconnection Type:
Select Always.on, On.demand, or Manual.
Maximum Idle Time:
Enter a maximum idle time during which the
Internet connection is maintained during
inactivity.
MTU Size:
You may need to change the MTU (Maximum
Transmission Unit) for optimal performance
with your specific ISP. The maximum/default
MTU size is 1492.
Attain
Select this option if you want the DAP-1260L
DNS Automatically:
to get the DNS (Domain Name System) server
IP address automatically.
Set DNS Manually:
Select this option if you want to manually
enter the DNS Server IP address(es). Fields to
enter the Primary and Secondary DNS server IP addresses will appear after you select this option.
DNS Servers:
Enter the Primary and Secondary DNS server IP address assigned by your ISP.
Clone MAC Address:
The default MAC address is set to the MAC address on the AP (Access Point). You can click the Clone.Your.PC's.MAC.Address
button to replace the AP's MAC address with the MAC address of your Ethernet card. It is not recommended that you change
the default MAC address unless required by your ISP.
D-Link DAP-1260L User Manual
PPPoE
40
Advertisement
Table of Contents
