Connecting The Usb Using The Included Usb Cord Clamps - Brother PR1055X Operation Manual

Connecting the USB using the included USB
cord clamps
When connecting the machine to a computer, use the
included USB cord clamps to keep the cord away from the
carriage.
Included cord clamps
Installation positions of the USB cord clamps
a
b
1 Front screw hole on the side of the machine
2 Rear screw hole on the side of the machine
a Using the included Allen screwdriver, remove the
protective cap covering the front screw on the side of
the machine.
• Insert the end of the Allen screwdriver into the hole in
the protective cap, and then lightly pull out the
protective cap to remove it.
Note
• Do not insert the Allen screwdriver too far into the
hole in the protective cap; otherwise, the machine
or the Allen screwdriver may be damaged.
b Open the USB cord clamp.
• With your fingernail, press on the tab to open the
clamp.
1 Tab
a
c Hold the clip end of the USB cord clamp, and then
firmly insert the other end into the screw hole where
the protective cap was removed.
a
As described in steps
d
protective cap from the rear screw hole on the side of
the machine, and then insert an opened USB cord
clamp.
e Check that the USB cord clamps have been firmly
inserted into the front and rear screw holes on the side
of the machine.
• If the USB cord clamps are not firmly inserted into the
screw holes, they are not correctly installed. Firmly
insert the cord clamps into the screw holes.
f Pass the USB cable through the front USB cord clamp,
and then close the clamp to secure the cable.
• When passing the USB cable through the clamp, do
not insert it with excessive force; otherwise, the clamp
may break.
g Using the same operation described in step
the USB cable with the rear USB cord clamp.
h Arrange the USB cable between the USB cord clamps
so that the cable does not interfere with the operation
of the machine.
Memo
• Store the protective caps, which were removed in
a
step , in the included accessory case so they
will not be lost.
ADVANCED EMBROIDERY
c
through , remove the
e
, secure
131
3