Setting Up The Machine; Remove The Fixing Plates - Brother PR1055X Operation Manual

Setting up the machine

When setting up the machine, adjust the legs so that the
machine is steady.
a Make sure that all packing tape affixed to the machine
is peeled off and that all packing material is removed.
Set up the machine while making sure that there is
b
sufficient space around it.
For details on the setup location, refer to page 17.
c Adjust the legs so that the machine is steady.
Use the included wrench to loosen the lock nut on the
leg that you wish to adjust.
 The foot can be turned.
d Use the included wrench to turn the adjustable foot
nut on the foot.
Turning the nut in direction 1 lengthens the leg; turning
the nut in direction 2 shortens the leg.
• Adjust all four legs so that they securely contact the
desk or table, and the machine is level.
e After adjusting the legs to the desired length, use the
included wrench to tighten the nuts.
f Press down on each corner of the machine to check
that it is stable.
If it is still unstable, perform steps
to adjust the legs.
18
1 Lock nut
2 Adjustable foot nut
1 Adjustable foot nut
1 Lock nut
c e
through again

Remove the fixing plates

CAUTION
• Remove the fixing plates before turning on the
machine, otherwise the machine may
malfunction.
a Using the included Phillips screwdriver, remove each
of screws on the fixing plates.
1 Screws
2 Fixing plates
Memo
• After removing the fixing plates, be sure to keep
them to be used again. Before transporting the
machine, consult your authorized Brother dealer.