Using The Optional Bobbin Winder; Precautions; Optional Bobbin Winder And Its Accessories - Brother PR1055X Operation Manual

Note
• If the built-in camera cannot detect the location of
the embroidery positioning sticker, the following
error message appears. Touch
jumbo frame to its previous orientation, and then
perform the procedure again starting from step
m Remove the embroidery positioning sticker from the
fabric.
n Touch to select the next section of the pattern to
be embroidered, and then touch
o Touch .
p Touch , and then press the "Start/Stop"
button to start embroidering the next section of the
pattern.
142
USING THE OPTIONAL BOBBIN
WINDER
, return the
When winding the bobbin thread onto a metal bobbin, use
the optional bobbin winder. The procedures for using the
h
.
optional bobbin winder are described below.

Precautions

For precautions concerning the power supply, refer to
page 22.
• Be sure to place the bobbin winder on a level,
stable surface.
• Be sure to use the bobbins supplied with this
bobbin winder.

Optional bobbin winder and its accessories

Check that the following bobbin winder and accessories are
included. When the part code is "*", contact your authorized
Brother dealer.
.
1.
c
1 Main power switch
2 Bobbin winder shaft
3 Hole for thread guide
4 Hole for spool pin
5 DC input connector
2.
3.
CAUTION
Part Name
Part Code
Bobbin winder
PRBW1
a
e
Spool pin
XC5949-051
Spool cushion
XA0679-050