Brother PR1055X Operation Manual page 28

■ General settings
26
• When [Thread Sensor] is set to [OFF], the
1
machine cannot detect tangled upper thread.
2
Continuing to use the machine with tangled
thread may cause damage.
3
1 The machine can be set so that the opening screen is
4
5
2 Select settings for the [Eco Mode] and [Shutoff Support
3 Select the length of time until the screen saver appears.
4 Select the image of the screen saver. (page 27)
5 Adjust the brightness of the screen display.
6 Adjust the brightness of the embroidery light.
7 Adjust the brightness of the embroidery light when
6
8 Adjust the volume of operation beep. Increase the
7
9 Adjust the volume of error notification. Increase the
8
9
0 Select the display units for embroidering (mm/inch).
A Select the display language. The keys and messages
0
B Select the Link function [ON] or [OFF]. You can choose
A
C Set the [Manual Color Sequence] [ON] or [OFF].
D Turn both the upper and bobbin thread sensors [ON] or
E Change the shape of the pointer when a USB mouse is
F [Total Count] shows the total number of stitches
B
G [Total Time] shows the total amount of time that the
C
*
D
E
H Shows the internal machine number for this machine.
I Shows the version of the software installed on this
• Install the latest software. Check with your local
F
G
H
I
CAUTION
either displayed ([ON]) or not displayed ([OFF]) when the
machine is turned on.
Mode]. (page 27)
lighting effects are used to notify that the thread spool
must be changed or an error has occurred.
number for louder volume, decrease for softer volume.
number for louder volume, decrease for softer volume.
appear in the selected language.
the USB cable connection or the wireless LAN
connection. (page 132)
(page 58)
[OFF]. If it is turned [OFF], the machine can be used
without upper thread.
used.
embroidered, and [Trip Count] shows the number of
stitches that have been embroidered since the
machine's last maintenance.
machine has been used, and [Trip Time] shows the
amount of time that the machine has been used since
the machine's last maintenance.
Use counters F and G as a standard for performing
periodic maintenance and for receiving
maintenance for the machine.
machine.
Note
authorized Brother dealer or at " http://s.brother/
cubah/ " for available updates (page 192).