Brother PR1055X Operation Manual page 97

■ If the bobbin thread breaks or runs out
a Touch , and then press the thread trimming
button.
 The upper thread is trimmed.
• If the bobbin thread breaks or runs out, also trim the
upper thread.
b Remove the stitches embroidered only with the upper
thread.
Pull the trimmed end of the upper thread.
• If the stitches cannot be cleanly removed, trim the
thread with scissors.
■ If the bobbin thread ran out, replace the
bobbin at this point in the procedure.
c Replace the bobbin with a bobbin wound with bobbin
thread. (page 33)
• If the hook cover can be opened, replace the bobbin
without removing the embroidery frame from the
machine.
• If the machine bed is hidden, for example, with a bag-
shaped piece of fabric, or if the hook cover cannot be
opened, temporarily remove the embroidery frame.
(page 90) After replacing the bobbin, re-attach the
embroidery frame. (page 64)
Note
If the embroidery frame is removed before
embroidering of the pattern is finished, take caution,
otherwise the pattern may become misaligned.
• Do not apply extreme pressure to the framed fabric
and cause it to become loose.
• When removing and re-attaching the embroidery
frame, do not allow the frame to hit the carriage or
the presser foot.
If the carriage is hit and moves, turn the machine
off, then on again. The correct frame position at the
time that the machine was stopped is stored in the
machine's memory, and the embroidery frame is
returned to the correct position.
• When the embroidery frame is re-attached, make
sure that the pins on the left and right arms of the
embroidery frame holder securely fit into the holes
in the handles on the embroidery frame.
d Go back through the stitching in the same way as that
b
described in step through
thread breaks" on page 93, and then continue
embroidering.
BASIC EMBROIDERY
g
of "If the upper
95
2