Brother PR1055X Operation Manual page 140

b Position the wide table so that the notch at the center
aligns with the machine bed, and then place the wide
table flat on the guide plates.
1 Machine bed
2 Guide plate
3 Notch in wide table
c Pull the wide table toward you until the pins on the
mounting brackets (attached on each side to the
bottom of the wide table) fit into the notches in the
guide plates.
1 Pin
2 Notch
138
d Slide in the wide table while supporting it so that it
remains level. Push the wide table in until it lightly
touches the machine.
• If the wide table does not move smoothly, slightly lift
it up, and then slide it in.
e While looking below the wide table, lightly lift it up,
and then lower it so that the screw fits into the notch at
the front of the guide plate.
1 Notch at front
a