Changing The Position Of A Sticker - Brother PR1055X Operation Manual

Changing the position of a sticker

If the selected pattern or positioning stickers for connecting
the next pattern do not easily fit in the embroidering area,
follow the on-screen instructions that appear after step
page 111 in order to move the positioning stickers.
For an example, the on-screen instruction appears when you
use the embroidery frame with a size of 10 cm × 10 cm (4
inches × 4 inches) to connect patterns as shown below.
a
a Refer to steps through
patterns" on page 109 using the embroidery frame
with a size of 100 mm × 100 mm (4 inches × 4 inches)
to embroider the first pattern and to connect the
second pattern.
Note
• When referring to steps
"Connecting three patterns" on page 109, make
sure you select the pattern position to reflect this
exercise.
114
m
on
1 Pattern A
2 Pattern B
m
of"Connecting three
a m
through of
b Following message appears in step
pattern or affixed positioning stickers are close to
being out of the embroidering area. Follow the
instructions and then touch
1 Embroidering area
1 Pattern to be embroidered next
2 Embroidery sheet
Note
• If the message that could not recognize the
embroidery positioning sticker appears, rehoop the
fabric as indicated in the screen, and then touch
.
c After the positioning stickers have been detected, the
message to inform you that it recognized the
embroidery positioning sticker appears. Touch
and then remove the stickers.
d Affix the two positioning stickers again according to
the on-screen instructions so that the next pattern or
positioning marks can fit in the embroidery area.
 Touch
so that the camera detects the first
positioning sticker.
n
if the next
.
1
,