SWITCHING THE THREAD COLORS
ON THE SCREEN
If a thread color on the spool stand is different than the
needle position thread color on the screen, the thread
colors on the screen can be switched to match the spool
stand thread color position.
Memo
• This function is not available when you set [Manual
Color Sequence] to [ON] in settings screen.
a
Touch
in the embroidering screen.
The spool selection screen appears.
b
Touch the number of the first needle bar that will be
switched.
• To cancel the selection, touch the same needle
number again.
c
Touch the number of the other needle bar that will be
switched. The two needle numbers are connected with
an arrow.
d
Touch
to switch the two thread colors.
e
After making the desired changes, touch
■ To cancel the thread color settings for all
previously stitched design
Memo
• The color settings will be completely canceled even
if the machine is in the middle of the embroidery.
a
Touch
The thread color setting is canceled.
b
Touch
Thread colors are assigned by the machine again,
regardless of the previous spool setting.
Note
• This function will not clear anchor settings of any of
the needles which have been assigned a thread
color. (page 121)
.
BASIC EMBROIDERY
.
.
2
57