Brother PR1055X Operation Manual page 165

c When scanning is finished, specify the necessary
settings in the scan image confirmation screen.
Change the settings to adjust the image so it can easily
be converted to the desired pattern.
1
2
1 [Max. Number of
The number of colors in an image will
Colors] be reduced less than the number
specified here, and then the outline
will be extracted.
2 [Remove Background] Select whether or not the
background color will be included as
one of the colors.
3 [Line]
Select whether or not the outline will
be detected as a line. A thick outline
can also be detected as a region.
When detected as a line, the line
thickness and color can be specified.
Memo
• Touch to detect the outline.
Line thickness can be specified from 1.0 mm (1/16
inch) to 5.0 mm (3/16 inch).
• Touch to select the outline color. Select by
touching the color, or moving
in the color selection screen.
d Move to frame the image for the pattern.
e Touch .
 The screen for confirming the converted image
appears.
f In the screen for confirming the converted image,
adjust the image as necessary as in step
3
*
 After changes to the settings described above have
g Touch
 The pattern drawing screen appears.
h If necessary, edit the scanned image.
icon using
*
• During scanning, the small dots that appear and
MY DESIGN CENTER
To display the image before being converted, touch
. Compare the images before and after
being converted, and then change the settings if
necessary.
been applied, changes to
to check that the image is as desired.
.
After the scanned image is converted to stitching, it
appears as a background in the pattern drawing
screen. Use gauge 1 to adjust the transparency of
the background. Each touch of
background, making the illustration pattern darker.
Each touch of darkens the background, making
the illustration pattern lighter.
Note
unnecessary lines can be erased.
c
.
4
. Touch
1
lightens the
163