Brother PR1055X Operation Manual page 85

The numbers indicate the thread path for each of the
numbered needle bars. Be very careful to correctly thread the
needle bars.
b Pass the thread of a specified color through the holes
on the thread guide, making sure that you have the
thread color matched to the coordinating needle bar.
Pass the thread from spool pins 1, 3, 5, 6, 8 and 10
through the holes in both thread guides A and B.
Pass the thread from spool pins 2, 4, 7 and 9 through
the hole in thread guide B only.
1 Thread guide A (There are 6 holes in this thread guide)
2 Thread guide B (There are 10 holes in this thread guide)
c Pass the thread through the hole (with the
corresponding needle bar number) in thread guide C,
then through the corresponding hole in thread guide D.
As an example, the threading for spool pin 1 is shown.
1 Thread guide C
2 Thread tension lever
3 Holes in thread guide C
4 Thread guide D
Note
• Before threading, make sure to slide the thread
tension lever to the left so that the holes in thread
guide C are fully open.
d Pass the thread through the hole in the number 1 upper
thread guide and pull the thread toward you.
1 Hole in upper thread guide
BASIC EMBROIDERY
83
2