Brother PR1055X Operation Manual page 147

c Pass the thread through the hole in the left of the
thread guide toward the front of the winder.
1 Hole in the thread guide
d Pass the thread around the tension disc as shown in the
illustration. Make sure that the thread is correctly fed
into the tension disc.
1 Tension disc
e Pass the thread through the hole in the right of the
thread guide toward the back of the machine.
1 Hole in the thread guide
f Wind the thread clockwise around the bobbin 4 or 5
times, as shown in the illustration.
g Pass the end of the thread through the guide slit in the
bobbin winder seat, and pull the thread. The cutter will
cut the thread.
1 Guide slit
2 Bobbin winder seat
Note
• Be sure to follow the procedure described. If the
bobbin is wound without the thread being cut with
the cutter, when the bobbin thread runs low, the
thread may become tangled around the bobbin
and cause the needle to break.
Slide the bobbin holder, until it clicks into place.
h
1 Bobbin holder
ADVANCED EMBROIDERY
145
3