Table of Contents
Advertisement
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
2
Place the pattern that you wish to recall into
the "Removable Disk" folder.
After writing the data to the embroidery
machine, the key for that pattern appears
in the screen.
3
If the desired pattern can still not be written,
repeat steps
1
2
and
.
Connecting the USB
using the included USB
cord clamps
When connecting the embroidery machine to a
computer, use the included USB cord clamps to
keep the cord away from the carriage.
Included cord clamps
Installation positions of the USB cord clamps
1 Front screw hole on the side of the machine
2 Rear screw hole on the side of the machine
1
Using the included Allen screwdriver,
remove the protective cap covering the front
screw on the side of the machine.
• Insert the end of the Allen screwdriver into
the hole in the protective cap, and then
lightly pull out the protective cap to
remove it.
Selecting an Embroidery Pattern 171
1
2
5
Advertisement
Table of Contents
Troubleshooting
