Connecting The Power Cord - Brother KE-430HX Instruction Manual

3-14. Connecting the power cord

Be sure to connect the ground. If the ground connection is not secure, you run a high risk of receiving a serious electric
shock, and problems with correct operation may also occur.
<Seen from underneath table>
2381B
2454B
Control box
Green and yellow wire (ground wire)
KE-430HX/KE-430HS, BE-438HX/BE-438HS
7. Pour oil in through the two holes of the shuttle race base
assembly so that the felt (6) is lightly moistened.
NOTE:
• The two pieces of felt (6) should normally project by 0 to 0.5
mm from the hook race. Be careful not to push in the felt (6)
when lubricating.
• If there is no more oil on the felt (6) of the shuttle race base
assembly, problems with sewing may result.
<When using the needle cooler (option)>
If using the needle cooler (option) (1), fill it with silicone oil.
CAUTION
Leg
3959B
3. INSTALLATION
Connect cords that match the voltage
specifications.
<EU specifications>
(1) Filter box
(2) Screws [4 pcs]
(3) Staples [5 pcs]
(4) Power cord
1. Attach an appropriate switch and cable
to the power cord (4). (The green and
yellow wire is the ground wire.)
2. Insert the power plug
properly-grounded electrical outlet.
NOTE:
• Take care when tapping in the five
staples (3) to make sure that they do
not pierce the cords.
• Do not use extension cords, otherwise
machine operation problems
result.
into a
may
27