Temporary Needle Bar Setting - Brother PR1055X Operation Manual

e After specifying the desired settings, touch
• If the machine is temporarily turned off when it is
stopped at the specified location after embroidering,
you will be asked if you wish to continue
embroidering or select a new pattern when the
machine is turned on again.
Touch to continue embroidering. (page 97)
Memo
• If the machine is temporarily turned off, the settings
to stop the machine at color changes specified
before the machine was turned off are not
cancelled. However, the settings are cancelled if a
new pattern is selected.
• If a pattern with the settings to stop the machine at
color changes is saved, the settings to stop the
machine at color changes are also saved.

Temporary needle bar setting

After embroidering begins, the machine can be stopped at a
color change and a different needle bar can be specified for
the next color to be embroidered.
By substituting an upper thread color already threaded on a
different needle bar, the time for embroidering can be saved.
For example, similar color thread can be substituted for
temporary use.
a Touch .
 The temporary needle bar setting screen appears.
b Touch the key for the needle bar threaded with the
thread that you wish to embroider with.
 The needle bar number changes and
indicate the selected needle bar.
 To cancel the setting, touch
c Touch .
120
 The embroidering screen appears again.
.
• The thread color (needle bar) cannot be changed in
■ Uninterrupted embroidering (one color)
A selected pattern can be stitched out in one color instead
of multi color. The machine will hesitate but not stop
between color steps, and then continue till the pattern is
completed.
a Touch
• The selected pattern will be embroidered in one
• Touch
b Touch
c Touch the key for the needle bar threaded with the
thread you wish to embroider uninterruptedly.
 The thread color sequence display and pattern for the
appears to
• Even if uninterrupted embroidering has been set,
.
• After finishing the embroidery, uninterrupted
Memo
the middle of an area that is being embroidered.
in the embroidering settings screen.
color, instead of changing the thread while
embroidering.
again to return to the pattern's original
settings.
to continue to the embroidering screen.
thread color of the selected needle bar appear.
Memo
the DST thread trimming function can be used.
(page 123)
embroidery will be canceled.