Operating States/Error Signals; Signals For Operating States - Otto Bock Genium Instructions For Use Manual

Declaration of conformity according to the applicable European directives
Serial number
Lot number
Caution, hot surface
Protect from moisture
Please note the instructions for use
Check
Ottobock Data Station.

17.2 Operating states/error signals

The prosthesis indicates operating states and error messages through beeps and vibration signals.

17.2.1 Signals for operating states

Battery charger connected/disconnected
Beep signal
1x short
Mode switching
INFORMATION
When mute mode (silent mode) is activated, no beep and vibration signals are generated.
INFORMATION
If the Volume parameter is set to '0' in the Cockpit app, there are no beep signals (see Page 85).
Beep signal Vibration sig­
nal
1x short 1x short
1x long 1x long
1x short 1x short
2x short 2x short
3x short 3x short
Genium 3B1-3/3B1-3=ST
the product settings
Vibration signal
3x long
1x before beep signal
Additional action performed
Mode switching using the Cockpit
app
Bouncing on the forefoot followed
by unloading the prosthetic leg
Weight taken off prosthetic leg
and leg kept still for 1 second
Weight taken off prosthetic leg
and leg kept still for 1 second
Weight taken off prosthetic leg
and leg kept still for 1 second
using the corresponding
Event
Charging mode started (3 sec. after connecting the bat­
tery charger)
Self-test completed successfully, product is operational
Event
Mode switching is performed using the
Cockpit app.
Bouncing pattern recognised.
Switching to basic mode (mode 1) car­
ried out.
Switching to MyMode 1 (mode 2) car­
ried out.
Switching to MyMode 2 (mode 3) car­
ried out.
Appendices
adjustment software of the
99