Symbols Used; Signals For Operating States - Otto Bock DynamicArm Plus Instructions For Use Manual

12 Appendices

12.1 Symbols Used

Declaration of conformity according to the applicable European directives
Manufacturer
Compliance with the requirements according to "FCC Part 15" (USA)
In some jurisdictions it is not permissible to dispose of these products with unsorted household
waste. Disposal that is not in accordance with the regulations of your country may have a detri­
mental impact on health and the environment. Please observe the instructions of your national
authority pertaining to return and collection.
Compliance with the requirements under the "Radiocommunications Act" (AUS)
Serial number (YYYY WW NNN)
YYYY – year of manufacture
WW – week of manufacture
NNN – sequential number
Non-ionising radiation
Medical device
Article number
12.2 Operating states/error signals
12.2.1 Warnings/error signals
Beep signal
1 x long
1 x long
2 x

12.2.2 Signals for operating states

Sound sequence
DynamicArm Plus 12K110N=*
Vibration signal
1 x
5 x
1 x
Event
Low, low, The product has
high, low been switched
on.
Error
Critical error
(e.g. a sensor is not opera­
tional)
Severe error
(e.g. temperature of the lift­
ing motor too high)
Malfunction
(e.g. incompatible com­
ponent connected)
Elbow joint Electric wrist
rotator
Function is Function
present present
Appendices
Required action
Turn the product off and on
again or, with the product
turned on, connect the bat­
tery charger. Contact
Ottobock Service if the
error has not been
resolved.
Hand/Greifer
is Function
present
is
69