Table of Contents
Advertisement
Figure 4-7: SATA Drive Cable Connection
Step 3:
Connect the cable to the SATA disk. Connect the connector on the other end
of the cable to the connector at the back of the SATA drive. See Figure 4-7.
Step 4:
To remove the SATA cable from the SATA connector, press the clip on the
connector at the end of the cable.
NOTE:
The connector locations in the diagram above are just for reference.
For the exact locations, please see Section 3.2.16.
Page 58
gKINO-V/R1000 SBC
Step 0:
Advertisement
Table of Contents
