Connecting The Patient Circuit - Breas Vivo 2 User Manual

4
• If using mains power, connect the AC plug to the mains supply outlet:
• If using DC power, connect the DC plug to the DC power outlet:
5 Make sure that the power outlet is not blocked, so that the cord can be unplugged
without difficulties.
5.4

Connecting the Patient Circuit

WARNING!
Read the chapter 2.4 Patient Circuit — Warnings and Precautions, page 21 Carefully to
make sure all conditions are considered and met.
The Vivo 2 is intended to be used with leakage circuits only. Recommended leak rate:
20 to 50 liters per minute at 10 cmH
1 Check that the circuit is clean and undamaged.
2 Connect the tube to the air outlet.
Doc. 007229 D-3
Item 1 in the figure: AC/DC power supply
Item 2 in the figure: DC/DC power supply
1
O.
2
Prepare the Vivo 2 for Use 61
User manual