Connecting The Vivo 2 To Power Supply - Breas Vivo 2 User Manual

2 Make sure that nothing can block
the patient air inlet at the back of the
Vivo 2, such as a curtain etc.
5.3

Connecting the Vivo 2 to Power Supply

This chapter describes how to connect a Breas power supply.
WARNING!
Read the chapter 2.2 Electricity — Warnings and Precautions, page 18 carefully to make
sure all conditions are considered and met.
CAUTION!
Mains isolation is provided by the approved AC/DC and DC/DC adapters. The
ventilator must only be powered by the approved AC/DC or DC/DC adapter
(accessory) listed in 10 Accessories, page 121.
1 Plug the DC plug by turning it into
the power port at the back of the Vivo 2.
2 Make sure that the mains cord is connected to the power adapter (a).
3 Turn the DC plug clockwise 90 degrees (b).
60 Prepare the Vivo 2 for Use
User manual
b
a
Doc. 007229 D-3