Input Channel Strip; Items In The Input Channel Strip - Yamaha PM5D Owner's Manual

INPUT channel strip

The INPUT channel strip is the section where you can control the principal parameters of the input channels.
This section is layered as shown in the following diagram; choose the CH 1-24 layer when you want to control input channels
1–24, or the CH 25-48 layer when you want to control input channels 25–48.
CH 1-24 layer
CH 25-48 layer

Items in the INPUT channel strip

2
3
4
5
6
7
8
9
A [CH 1-24]/[CH 25-48] keys
These keys select the layer (CH 1-24 or CH 25-48) con-
trolled by the INPUT channel strip. The LED of the
currently selected layer will light.
B [PRE] key
This selects the output location of the signal when send
level to MIX bus 1–24 is selected as the encoder func-
tion. The pre-fader signal is sent to the corresponding
MIX bus if this key is on, and the post-fader signal is
sent if this key is off.
C ENCODER [ON] key
This switches the function currently assigned to the
encoder on/off. By default, this switches the signal sent
from the input channel to MIX buses 1–24 on/off.
J
1
D Encoder
K
L
According to the selection in the ENCODER MODE
section / FADER FLIP section (➥ p.40), this encoder
adjusts the send level from the input channel to MIX
M
buses 1–24, the panning of the input channel, or the
level of the input channel in the layer that is not cur-
rently selected. By default, this adjusts the send level to
MIX buses 1–24.
N
E [SEL] key
This selects the input channel that you will control
from the SELECTED CHANNEL section or from
within the display.
O
F Name indicator
This displays the name that has been assigned to the
input channel.
P
G CH [ON] key
Switches the input channel on/off. If this key is off
(LED dark), no signal will be sent from that input
channel to the STEREO bus or MIX buses.
H Fader
This 100 mm fader adjusts the input level of the input
channel.
I [CUE] key
This key lets you cue-monitor the signal of the input
channel.
PM5D/PM5D-RH Owner's Manual
Operating section
5
37