Fade Time Screen - Yamaha PM5D Owner's Manual

In the case of parameters (such as those listed below) for
which two adjacent odd-numbered/even-numbered chan-
nels or modules share a single parameter, the parameter
will be excluded from recall only if recall safe is specified
for both channels/modules.
• GATE STEREO LINK
• COMP STEREO LINK
• DELAY GANG
• PAN MODE
• GEQ LINK
• ATT GANG
• MS DECODE
• FIXED/VARI
Note
• Selective Recall applies when a scene is recalled in PRE-
VIEW mode.
• When you recall a scene, there may be cases in which a
conflict in pairing settings between Recall Safe and Selec-
tive Recall causes the settings of a parameter to differ
between L and R channels. In such cases, the parameter
will be linked when it is next operated.

FADE TIME screen

Here you can specify how fader and pan will change
smoothly to their new values over a specified duration
when the scene is recalled.
1
A FADING ENABLE/DISABLE
Enables/disables the Fade function for fader levels.
Note
• The settings in the FADE TIME screen are independent for
each scene. If you edit these settings, you must store that
scene in order to make your changes effective.
• The Fade function will apply when you recall a scene for
which the ENABLE button is selected.
B INPUT CH PANNING ENABLE/DISABLE
(Input channel panning enable/disable)
If the ENABLE button is selected, the Fade function
will also apply to the PAN (BALANCE) parameter of
input channels. This button is independent from the
FADING ENABLE/DISABLE (
lowing two buttons to select the input channels to
which this will apply.
• When the ALL INPUT button is on
The Fade function will apply to the PAN (BALANCE)
parameter of all input channels.
• When the SAME AS FADING button is on
The Fade function will apply to the PAN (BALANCE)
parameter of only the input channels you select in
C FADE TIME/START OFFSET
Use the following two buttons to select the parameters
that can be viewed/edited in the FADE TIME screen.
The indication at the right shows which button is cur-
rently selected.
• When the FADE TIME button is on
Edit the time (fade time) over which the fader or pan
parameter of the corresponding channel will reach the
new value when you recall a scene for which the Fade
function is enabled.
PM5D/PM5D-RH Owner's Manual
FADE TIME
2 3
1 ) setting. Use the fol-
Reference section
4 .
167