Yamaha PM5D Owner's Manual page 226

OUTPUT EQ function
1 2
5
A Channel selection
Select the output channel that you want to edit. You
can use eight-band EQ (four UPPER bands + four
LOWER bands) for MIX channels and STEREO A/B
channels, and four-band EQ for MATRIX channels.
If a channel is paired (or if a STEREO A/B channel is
selected), a heart symbol is displayed at the right. For
MIX channels or MATRIX channels, you can click this
symbol to enable/disable pairing.
B EQ ON/OFF (EQ on/off)
Turns the EQ on/off for that channel.
C EQ LINK GROUP
Selects the EQ link group (A–H) to which the EQ of
that channel belongs. EQ parameters are linked for
output channels belonging to the same group.
Note
The EQ of MIX channels and STEREO A/B channels can be
assigned only to groups A–F, and the EQ of MATRIX chan-
nels can be assigned only to groups G/H.
D LIBRARY
This button accesses the OUTPUT EQ LIBRARY
screen (➥ p.228), where you can store/recall EQ
library settings for output channels.
E EQ TYPE
Selects the type of EQ. Turning the TYPE I button on
selects the algorithm used in the 02R series. Turning
the TYPE II button on selects a newly developed algo-
rithm. TYPE II reduces the interference between bands.
F EQ graph
This graph shows the approximate response of the EQ
parameters. The colored vertical lines indicate the
FREQ (center frequency) of the band for the parame-
ter at which the cursor is located. (The color of each
line matches the knob markings for each band.) The
response curve will change when you edit the Q or
GAIN of each band.
G Level meter
These meters indicate the peak levels before EQ and
after EQ. If the signal clips before EQ, the OVER seg-
ment will light.
H EQ FLAT
This button resets the GAIN parameters of all bands to
the default value (±0.0 dB). When you click this but-
ton, a confirmation message will appear.
I LOWER/UPPER (only for MIX channels and
STEREO A/B channels)
This indicator shows which four bands (LOWER or
UPPER) are selected in the SELECTED CHANNEL
section of the panel. The text label of the selected group
is displayed in yellow.
226
PM5D/PM5D-RH Owner's Manual
3 6 4
9 8 7
Reference section
L M
J
K
J Knobs
These knobs adjust the Q, FREQ (center frequency),
and GAIN (amount of boost/cut) for each band.
K BYPASS
These buttons bypass each band of the EQ.
L
(LOW shelving)
If this button is on, the LOW EQ will function as a
shelving-type EQ. The Q knob will disappear.
M HPF (High Pass Filter)
If this button is on, the LOW EQ will function as a
high-pass filter. The Q knob will disappear, and the
GAIN knob is used to switch the HPF on/off.
N (HIGH shelving)
If this button is on, the HIGH EQ will function as a
shelving-type EQ. The Q knob will disappear.
O LPF (Low Pass Filter)
If this button is on, the HIGH EQ will function as a
low-pass filter. The Q knob will disappear, and the
GAIN knob is used to switch the LPF on/off.
N O