Yamaha PM5D Owner's Manual page 281

ALL ON [ALL CH ]
Turn on the signals sent from all input channels to
the specified MIX bus.
ALL OFF [ALL CH x ALL MIX]
Turn off the signals sent from all input channels to all
MIX buses.
ALL ON [ALL CH x ALL MIX]
Turn on the signals sent from all input channels to all
MIX buses.
❏ When the PRE/POST button is on
This screen shows the send positions of the signals sent
from the input channels to the MIX buses.
Each indication has the following significance.
(green) . . . PRE EQ (immediately before
the EQ)
(yellow) . . PRE FADER (immediately
before the fader)
(gray) . . . . POST ON (immediately after
the [ON] key)
(red) . . . . . POST TO ST (immediately after
the [TO ST] key)
To change the send position of a signal, move the cur-
sor to the grid where the desired channel and MIX bus
intersect, and press the [ENTER] key, or click, or turn
the [DATA] encoder.
If the PRE/POST button is on, the send position for all
grid locations can be changed simultaneously. To do
so, hold down the [SHIFT] key and click the desired
grid. (Alternatively, move the cursor to the desired
grid; then hold down the [SHIFT] key and press the
[ENTER] key.) When the following window appears,
select one of the following choices and click the OK
button.
ALL PRE [ALL MIX
Specify pre-fader as the send position for signals sent
from the specified input channel to all MIX buses.
ALL POST [ALL MIX
Specify post-fader as the send position for signals sent
from the specified input channel to all MIX buses.
ALL PRE [ALL CH
Specify pre-fader as the send position for signals sent
from all input channels to the specified MIX bus.
ALL POST [ALL CH
Specify post-fader as the send position for signals sent
from all input channels to the specified MIX bus.
ALL PRE [ALL CH x ALL MIX]
Specify pre-fader as the send position for signals sent
from all input channels to all MIX buses.
ALL POST [ALL CH x ALL MIX]
Specify post-fader as the send position for signals sent
from all input channels to all MIX buses.
C Grid
This area shows various settings for the signals sent
from the input channels (horizontal rows) to the MIX
buses (vertical columns). The red lines extending
toward the left and upward indicate the corresponding
input channel and MIX bus for the grid at which the
cursor is now located.
D SELECTED PARAMETER (currently selected
parameter)
This indicates the input channel and MIX bus for the
grid where the cursor is currently located. The four
boxes at right indicate the values for the grid where the
cursor is currently located.
PM5D/PM5D-RH Owner's Manual
]
]
]
]
4
Reference section
281