Yamaha PM5D Owner's Manual page 201

(If you again switch back to horizontal pair mode, the
channels will return to their previous number.) How-
ever, please note that this simply means the input
channel that was previously called "channel 2" is now
called "channel 25"; the name and parameter settings
of that channel have not changed.
In the various screens of the display (except for the
TRACKING RECALL screen and the FADER VIEW
screen), switching the pair mode will only change the
displayed numbers; the arrangement of the input chan-
nels will not change.
B PAN NOMINAL POSITION
Here you can specify whether a signal will be at nomi-
nal level when panned to center, or at nominal level
when panned far left or far right. Choose one of the fol-
lowing two settings. You can choose independently for
monaural channels and paired channels.
• CENTER
The signal will be at nominal level (+0 dB) when
panned to the center, and will rise +3 dB when panned
to far left or far right.
• L ↔ R
The signal will be at nominal level (+0 dB) when
panned to far left or far right, and will decrease
–3 dB when panned to the center.
Hint
The current setting is also shown by the graph below the
buttons.
3 5
4
C BUS SETUP
This area indicates the MIX bus mode (VARI/FIXED)
for every two adjacent odd-numbered/even-numbered
MIX buses. You can edit the setting by clicking the
buttons at the left and right.
D STEREO B
Select one of the following two choices to specify how
the STEREO B bus will function.
• USE AS STEREO BUS
If this button is on, the STEREO B bus will function as
a conventional stereo bus; the same signal as the STE-
REO A bus will be sent to it.
• USE AS CENTER BUS
If this button is on, the STEREO B bus will function as
the CENTER bus of LCR mode. When you turn this
on, the CENTER bus output signal will be added to the
L/R channels of the STEREO A bus, allowing LCR
playback (three-channel playback). (The monitor sig-
nal will also be played back from the three MONITOR
OUT connectors L/C/R.
Note
If the USE AS STEREO BUS button is on, LCR mode is
disabled.
E SURROUND BUS ALLOCATION
Choose which of the following two ranges of MIX bus
will be used as surround buses.
MIX 1-8 . . . . . MIX bus 1–8
MIX 9-16 . . . . MIX bus 9–16
F SURROUND MODE
Choose one of the following as the surround mode
when using the Surround Pan function (➥ p.132).
• STEREO
This is conventional stereo mode.
• 3-1ch
This mode uses four channels: L (front left), C (front
center), R (front right), and S (surround).
L
(front left)
6
• 5.1ch
This mode uses six channels: L (front left), C (front
center), R (front right), Ls (rear left), Rs (rear right),
and LFE (subwoofer).
L
(front left)
Ls
(rear left)
/
PM5D/PM5D-RH Owner's Manual
C R
(front center) (front right)
S
(surround)
LFE
(subwoofer)
C R
(front center) (front right)
Rs
(rear right)
Reference section
201