Cue/Solo Screen - Yamaha PM5D Owner's Manual

6
F Level meter
These peak level meters indicate the level of the output
signal from the MONITOR OUT jacks. You can select
the level detection point to be immediately before the
delay that is provided on the MONITOR/CUE bus
output (when the PRE DELAY button is on) or imme-
diately after the delay (when the POST DELAY button
is on).
G CUE INTERRUPTION
If this button is on, the cue/solo signal will also be out-
put from the MONITOR OUT jacks while the Cue/
Solo function is active. During this time, the monitor
source selected in the MONITOR SOURCE section
will be disabled.
If this button is off, the cue/solo signal will never be
output from the MONITOR OUT jacks.
H MONITOR MODE
Here you can select one of the following two ways in
which the signal will be output from the MONITOR
OUT jacks.
STEREO . . . . The L/R channels will be output in
stereo.
MONO . . . . . . The L/R channels will be mixed, and
output in monaural.
The status of these two buttons is linked with on/off
operations of the [MONO] key in the MONITOR sec-
tion of the panel.
I OUTPUT ON/OFF
This is an on/off switch for the signal that is output
from the MONITOR OUT jacks.
J
K
J MONITOR INSERT
This area shows the input jacks (and input channels of
the digital I/O card) that are inserted into the MONI-
TOR OUT L/C/R channels. The input level of the
inserted signal is shown by the level meter at the right.
If GEQ or EFFECT is inserted, the corresponding
information is shown here.
K INSERT ON/OFF
This button enables/disables insertion.
L PATCH
Displays the INSERT PATCH screen.

CUE/SOLO screen

7
Here you can make settings and perform operations
related to the Cue/Solo function.
8
9
A SOLO ON/OFF
This button selects either
CUE mode or SOLO mode
as the type of monitoring
performed by the [CUE]
key. When you turn this
button on, a confirmation
message will appear. Each
mode operates as follows.
• CUE mode (SOLO ON/
OFF button is off)
The signal of the channel
whose [CUE] key is
pressed will be sent to the
dedicated CUE bus, and
monitored via the CUE
bus from the CUE OUT
jacks, MONITOR OUT
jacks (if CUE INTERRUP-
TION is on), and PHONE
L
jack. This mode lets you
monitor the signal of a
specific channel without
affecting other buses.
• SOLO mode (SOLO ON/OFF button is on)
When using Input Solo, the familiar "solo" function is
enabled; only the signal of the channel whose [CUE]
key is pressed will be sent to the MIX, MATRIX, and
STEREO A/B buses, and other channels will be muted.
When using Output Solo, only that channel will be on.
The signal of a channel whose [CUE] key is pressed can
also be monitored from the CUE OUT jacks, MONI-
TOR OUT jacks, and PHONES jack.
PM5D/PM5D-RH Owner's Manual
CUE/SOLO
1
2
3
4
Reference section
217