Directly Outputting An Input Channel - Yamaha CL1 Reference Manual

5.
Use the category and the output port select buttons to specify the output port that
will be used as insert-out, and press the CLOSE button.
You will return to the INSERT/DIRECT OUT popup window.
6.
Press the INSERT IN button.
The PORT SELECT popup window will appear, allowing you to select the input port used for
insert-in. The categories correspond to the following input ports.
• OMNI.......................................... OMNI1–OMNI8
• SLOT1 ......................................... SLOT1(1)–SLOT1(16)
• SLOT2 ......................................... SLOT2(1)–SLOT2(16)
• SLOT3 ......................................... SLOT3(1)–SLOT3(16)
• GEQ RACK ................................ GEQ1L(A)–GEQ16R(B) (Output channels only)
• EFFECT RACK ......................... FX1L(A)–FX8R(B)
• PREMIUM RACK .................... PR1L(A)–PR2R(B)
7.
Specify the input port you will use for insert-in, and press the CLOSE button.
8.
Press the INSERT ON/OFF button to turn it ON.
In this state, insert-out/in is enabled. Adjust the input/output levels of your external device if
necessary.
NOTE
• If you have selected the OMNI IN jack on the CL console
as the input port for insert-in, make the HA settings in the
INSERT IN HA field.
• Even if the INSERT ON/OFF button is OFF, the signal
selected for insert-out will continue to be sent.
9.
If you want to change the insert-out/in position, access the one-channel INSERT/
DIRECT OUT popup button, and press one of the three INSERT fields.
The INSERT field you pressed will be enabled.
10.
When you have finished making all settings, press the "x" symbol located in the
upper right to close the window.
You will return to the OVERVIEW screen.
11.
As desired, make insert settings for other channels as well.

Directly outputting an INPUT channel

The signal of an INPUT channel can be output directly from an OUTPUT jack on the I/O device, from
the desired OMNI OUT jack, or from the output channel of a desired slot.
1.
Connect your external device to an OMNI OUT jack, OUTPUT jack, or to an I/O card
installed in slot 1–3.
NOTE
If you install a digital I/O card in a slot and digitally connect an external device, you must
synchronize the word clock of the CL console and the external device (see
2.
Use the Bank Select keys in the Centralogic section to access the OVERVIEW screen
that includes the input channel that you want to output directly.
3.
Press the INSERT/DIRECT OUT field to access the INSERT/DIRECT OUT popup
window.
There are two variations of this popup window; one-channel and eight channel. Each window
view includes the following items.
INSERT/DIRECT OUT popup window (1ch)
2 3
1
DIRECT OUT field
Enables you to make settings for direct output. Press one of four fields to choose PRE HPF
(immediately before the HPF), PRE EQ (immediately before the EQ) or PRE FADER
(immediately before the fader), or POST ON (immediately after the [ON] key) as the direct
output position.
23
Input and output patching
page 198).
1
4
5
Reference Manual