Insert/Direct Out Point Screen - Yamaha PM5D Owner's Manual

INPUT PATCH function

INSERT/DIRECT OUT POINT screen

For each input channel, you can specify the point at which
insert in/out will be patched, and the point from which
direct output will be taken. Here you can also switch Insert
or Direct Output on/off.
INSERT/DIRECT OUT POINT
A Insert view
When you move the cursor to an insert I/O point (
the insert and direct output locations for that input
channel will be shown graphically.
2 3
B INPUT CH (Input channel)
This is the number of the input channel you are edit-
ing. Two paired channels are indicated by a heart
symbol shown at the left; settings
for these channels. You can click this symbol to enable/
disable pairing.
C INSERT ON/OFF
This button switches insert on/off for each channel.
This is linked for two paired channels.
Note
Be aware that if you turn on this button when either insert-in or
insert-out are unpatched, the signal will no longer be output
from the corresponding input channel.
256
PM5D/PM5D-RH Owner's Manual
1
4 ),
4
3 – 6 will be linked
Reference section
D INSERT I/O (Insert I/O point)
Here you can select one of the following as the insert-
in/out location for each channel.
PRE EQ Immediately before the EQ
POST EQ Immediately after the EQ
PRE DELAY Immediately before the delay
POST FADER Immediately after the fader
5
E DIRECT OUT ON/OFF
These buttons switch direct output on/off for each
channel.
F DIRECT OUT
Here you can select one of the following as the direct
output location for each channel.
PRE HPF Immediately before the high-pass filter
Immediately before the EQ (immediately
PRE EQ
after the PRE EQ of the INSERT I/O)
PRE FADER Immediately before the fader
POST ON Immediately after the CH [ON] key
6