Gpi Screen - Yamaha PM5D Owner's Manual

GPI screen

Here you can make settings for GPI (General Purpose
Interface) input/output, used to transfer control signals
between the PM5D and an external device.
3 4
1 2
A GPI IN port
These are the numbers of the GPI IN ports for which
you can make settings.
B GPI IN status
The yellow bar indicates the input signal voltage state
of the corresponding port. If the bar is not shown, the
signal is in the grounded state; if the bar is displayed to
the right edge, the signal is at the high level state. Use
3 ) field to select whether the signal is
the POLARITY (
active when low or high.
C POLARITY
This selects how GPI IN on/off will be detected. You
can choose Low Active (active when the key is
grounded) or High Active (active when key is open, or
when a high level signal is input).
D FUNCTION
E PARAMETER
These fields indicate the function that is executed when
the corresponding GPI IN port becomes active (or the
function that is controlled by the voltage value being
input from the GPI IN port), and option parameters
for that function.
To edit the settings, click the
open the GPI IN PORT ASSIGN window, and select
the function and parameter from the following table.
GPI
5
button at the left to
PM5D/PM5D-RH Owner's Manual
FUNCTION PARAMETER
NO ASSIGN — No assignment
Switches the Dimmer
DIMMER ON
function on/off
SOURCE=
Switches the monitor
MONITOR [monitor source
source
name]
Switches the monitor sec-
MONO ON
tion [MONO] key on
Switches the Talkback
LATCH function on/off (latched
operation)
TALKBACK
ON
Switches the Talkback
UNLATCH function on/off (unlatched
operation)
CH ON- Switches the channel on/
[channel name]
LATCH off (latched operation)
CH ON- Switches the channel on/
[channel name]
UNLATCH off (unlatched operation)
Modifies the fader value
FADER
[channel name] (LEVEL parameter)
LEVEL
according to the voltage
FRONT-REAR
according to the voltage.
PAN [SEL]
Modifies the surround pan-
LEFT-RIGHT ning (left/right) of the
PAN [SEL] selected channel accord-
ing to the voltage.
Modifies the surround pan-
ning (front/rear) of the
FRONT-REAR
selected odd-numbered
PAN [ODD]
channel according to the
voltage.
Modifies the surround pan-
SUR-
ning (left/right) of the
LEFT-RIGHT
ROUND PAN
selected odd-numbered
PAN [ODD]
channel according to the
voltage.
Modifies the surround pan-
ning (front/rear) of the
FRONT-REAR
selected even-numbered
PAN [EVEN]
channel according to the
voltage.
Modifies the surround pan-
ning (left/right) of the
LEFT-RIGHT
selected even-numbered
PAN [EVEN]
channel according to the
voltage.
While the external input is
USER
[User Defined active, executes the same
DEFINED
key bank / key operation as when the
KEY FUNC-
number] selected User Defined key
TION
is pressed
While the external input is
USER [User Defined
active, lights the LED of
DEFINED key bank / key
the selected User Defined
KEY LED number]
key
PEAK HOLD Switches the Peak Hold
ON function on/off
OSCILLA- Switches the Oscillator on/
—
TOR ON off
Switches the Solo func-
SOLO ON
tion on/off
Reference section
PM5D operation
177