Mixer Setup Screen - Yamaha PM5D Owner's Manual

SYS/W.CLOCK function
3 4 5
6 7 8
C Slot number / Card type
This area shows the type of digital I/O card installed in
slots 1–4.
D INPUT FORMAT (Input signal format)
E OUTPUT FORMAT (Output signal format)
Select one of the following as the method by which sig-
nals will be exchanged with a digital I/O card installed
in the slot when the PM5D is operating at a high sam-
pling rate (88.2/96 kHz).
• SINGLE
This setting allows transmission/reception of the nor-
mal number of channels when existing equipment that
operates at 44.1/48 kHz is connected. The sampling
rate will be converted for each channel of the digital I/
O card, and transmitted/received at half the sampling
frequency (44.1/48 kHz) of the PM5D. (This setting
can be selected only for slots in which a digital I/O card
that does not support 96 kHz is installed.)
• DOUBLE SPEED
This setting allows high sampling rate audio signals to
be transmitted/received without change when equip-
ment that operates at a high sampling rate (88.2/96
kHz) is connected. (This setting can be connected only
for slots in which a digital I/O card that supports 96
kHz is installed.)
• DOUBLE CHANNEL
This setting allows high sampling rate (88.2/96 kHz)
audio signals to be handled when existing equipment
that operates at 44.1/48 kHz is connected. Two chan-
nels of signals at half the PM5D's sampling frequency
(44.1/48 kHz) are transmitted/received together as a
high sampling rate monaural signal. (The number of
usable channels will be half.)
F FREQUENCY (Sampling frequency)
This indicates the sampling frequency of the signal
being input to each channel of the digital I/O card, in
sets of two channels.
G SRC (Sampling Rate Converter)
This button switches the Sampling Rate Converter on/
off, in sets of two channels. This is available only for
slots in which a digital I/O card with a built-in sam-
pling rate converter is installed.
H EMPHASIS STATUS
This indicates whether emphasis is applied to the input
signal, in sets of two channels. This is available only for
slots in which a digital I/O card is installed.
200
PM5D/PM5D-RH Owner's Manual

MIXER SETUP screen

Here you can make settings that apply to the entire PM5D
system.
MIXER SETUP
A PAIR MODE
Select one of the following two methods by which
input channels will be paired.
• HORIZONTAL PAIR
If this button is on, input channels of adjacent num-
bers (1/2, 3/4 ...) will be paired.
• VERTICAL PAIR
If this button is on, input channels of different layers
that share the same fader (1/25, 2/26 ...) will be paired.
This setting lets you use the faders of the INPUT chan-
nel strip to control up to 24 pairs (48 channels).
Hint
The graphic below the buttons will change according to the
pair mode you select.
When you switch from horizontal pair mode to verti-
cal pair mode, new numbers will be assigned to the
input channels as follows.
Channel 1 → no change
Channel 2 → Channel 25
Channel 3 → Channel 2
Channel 4 → Channel 26
Channel 47 → Channel 24
Channel 48 → no change
Reference section
1 2
: